How to Replace the 6602-001655 Dryer Belt Dryer Belt

Introduction

How to Replace a 6602-001655 Dryer Belt (Step-by-Step Guide)

Safety First

Before starting any appliance repair, always unplug the dryer from the power source. Dryer belt replacement requires opening multiple panels, so disconnecting power is critical for safety.

If you need a replacement belt, see the compatible dryer belt listed on our site before beginning the repair.

Tools You’ll Need

Before starting, gather the following tools:

• Putty knife
• Phillips screwdriver
• nut driver

Having these ready will make the repair go smoothly.

Step-by-Step Dryer Belt Replacement Instructions

1. Remove the Top Panel

Start by removing the screws located at the back of the dryer that secure the top panel.
Slide the panel backward slightly, then lift it off and set it aside.

2. Remove the Lint Screen

Pull the lint screen straight out from the top of the dryer.

Under the lint screen opening, remove the two Phillips screws securing the top panel.

3. Release the Top Panel

Using a putty knife, depress the two retaining clips that hold the top panel in place. These clips are typically located about one inch in from each side.

Lift the top panel and either lean it against a wall or secure it upright using a cord or strap so it stays safely out of the way.

4. Remove the Front Bulkhead

Disconnect the light bulb wire and remove it from its retainer.

Remove the screws securing the front bulkhead and the blower housing mounting screw.
Disconnect the moisture sensor wire harness.

Carefully pull the bulkhead off the cabinet frame and set it aside.

---

5. Remove the Old Dryer Belt

Reach under the drum and push the idler pulley to release tension on the belt.

Unthread the belt from the idler pulley and motor shaft, then remove it from the dryer.

---

6. Install the New Dryer Belt

Slide the new belt over the drum with the ribbed side facing down against the drum surface.

Route the belt around the motor shaft and idler pulley in a zigzag pattern, applying tension to the idler pulley as you loop it into place.

Rotate the drum by hand to help align the belt properly.

---

7. Reassemble the Dryer

Secure the wire harnesses back into their retainers on the front bulkhead.

Reinstall the bulkhead and secure it with mounting screws.
Reattach the blower housing screw, moisture sensor wire, and light bulb wire.

Reinstall the front panel by aligning the slots with the cabinet tabs.
Reconnect the door switch wire and secure the panel with screws.

Reconnect the control panel wiring and snap it back into position.

---

8. Reinstall the Top Panel

Align the top panel with the support brackets, slide it forward into place, and reinstall the rear screws.

---

9. Restore Power and Test

Plug the dryer back in and run a short cycle to confirm the drum spins correctly and the belt is properly installed.

---

Common Mistakes to Avoid

• Installing the belt with the ribbed side facing outward
• Forgetting to properly tension the idler pulley
• Pinching wires during reassembly
• Skipping the drum rotation check

---

Final Notes

Dryer belt replacement is a common repair when a dryer drum stops spinning. Always verify your dryer model number and belt compatibility before ordering a replacement.

If the dryer continues to make noise or fails to spin after belt replacement, related components such as the idler pulley or drum rollers may need inspection.